螺柱螺母壓鉚機
鑄鋼機體壓鉚機PRO.E圖
Type of the equipment QYP-06 |
Technical parameter 技術參數 |
Output working pressure the most greatly ( 大輸出工作壓力 ) |
60KN ( 6T )/80KN (8T) |
The equipment needs introduction to compress the pressure of the air 設備需輸入壓縮空氣的壓力 |
0.6MPa |
The main shaft puts the level and workingbench centre distance at the time of the initial state 初始狀態時主軸下平面與工作臺中心距離 |
150mm~200mm |
喉口深度 (mm) |
500mm / 700mm |
The greatest journey of the main shaft 主軸大行程 |
100mm / 150mm |
Keep the time of the invariable pressure 保持恒定壓力的時間 |
0~99 Second |
Heighten the strength pressure journey most 大增力壓力行程 |
6,10,15,20mm |
The equipment uses the voltage of the power 設備使用電源電壓 |
220V Alternating current 50HZ |
Mesa measurement of the table 工作臺面尺寸 |
180*70*90mm |
Mould handle hole measurement of the mould that the main shaft is installed 主軸裝上模模柄孔尺寸 |
¢ 20mm × 35mm |
Diameter of the main shaft 主軸直徑 |
¢ 35mm |
Control method of the safety in operation 操作控制方式 |
腳踏控制 |
上一篇:氣液增壓機
下一篇:可定壓/定程式液壓壓力機